Hi Judy - just for interest's sake, this is the new 'thing' that I'm getting when I try to connect to the PTZ cams. There's a little message at the bottom right of the page that says Stream 1 failed and new transmission protocols will be applied - or something to that effect. I've attached a scap for your reference in case no-one else has mentioned it.
The frustrating thing is that I get as far as having active cam controls, but no visual...then the message pops up.
Here's the scap I just took:
Thanks, Judy..!
Harrison Mills Cam Info
Moderator: Harrison Mills TA's
Re: Harrison Mills Cam Info
I've seen that from time to time, Yolande, including before we were having the sort of issues we're seeing this year, and I think someone else reported something similar recently, maybe at Delta - and I apologize for not responding then. When the cams are working somewhat normally, when I see that, usually I just reload the page and the stream loads correctly then. But when the signal from the site is having problems, that doesn't help.Yolande wrote: ↑Fri Jul 13, 2018 7:49 amHi Judy - just for interest's sake, this is the new 'thing' that I'm getting when I try to connect to the PTZ cams. There's a little message at the bottom right of the page that says Stream 1 failed and new transmission protocols will be applied - or something to that effect. I've attached a scap for your reference in case no-one else has mentioned it.
The frustrating thing is that I get as far as having active cam controls, but no visual...then the message pops up.
Here's the scap I just took:
Untitled 15130.jpg
Thanks, Judy..!
Thanks for posting the image - and because it happened from time to time in previous years, I'm guessing it's not a clue to the current problems we're having. Though I could be wrong!
2023 Eaglet Info ~ ~ ~ ~ ~ Helpful Hints
Re: Harrison Mills Cam Info
Hi Judy, and thanks...I’m grasping at straws here...!
Re: Harrison Mills Cam Info
I am getting this on t Mac
Re: Harrison Mills Cam Info
I think (and I do not know if this is correct) that sometimes the basic control page is pulled from our cache - so we can see that even though we're not really connected with the cam that generates the page. The image of the nest won't come in because that's not a static thing that could be stored - and I've no clue if it sometimes does the stream not found thing in those circumstances, or if that's totally different.
Bev, is that what you sometimes see when you can't get the cam - or what you always see? And I'm thinking you need to switch to Stream 3 before you can see an image on the Mac - right?
Bev, is that what you sometimes see when you can't get the cam - or what you always see? And I'm thinking you need to switch to Stream 3 before you can see an image on the Mac - right?
2023 Eaglet Info ~ ~ ~ ~ ~ Helpful Hints
Re: Harrison Mills Cam Info
JudyB wrote: ↑Fri Jul 13, 2018 10:58 amI think (and I do not know if this is correct) that sometimes the basic control page is pulled from our cache - so we can see that even though we're not really connected with the cam that generates the page. The image of the nest won't come in because that's not a static thing that could be stored - and I've no clue if it sometimes does the stream not found thing in those circumstances, or if that's totally different.
Bev, is that what you sometimes see when you can't get the cam - or what you always see? And I'm thinking you need to switch to Stream 3 before you can see an image on the Mac - right?
Hi Judy that is only want I see when I can't get the cams..... and you are right ..when I can get the cams I switch to stream 3 ..like here
Thanks .. Bev !